Bathroom & Kitchen Plumbing in Topeka, KS

Faucets and fixtures

Dripping faucets usually need a new cartridge or washer. Older faucets with worn seats may be better replaced. A plumber can fit new faucets, sinks and garbage disposals and check the shut-off valves while they're there.

Toilets

Running toilets, weak flushes and rocking bowls are common repairs. A toilet that rocks may have a failing wax seal, which can leak into the subfloor. Replacing an old high-volume toilet saves water on every flush.

Showers and tubs

Shower valves, diverters and tub spouts wear out over time. Converting a tub to a walk-in shower means moving the drain and valve and planning waterproofing before the tile goes on.

Remodels

Moving a sink, adding a bathroom in the basement or opening up a kitchen means new supply and drain lines. A basement bathroom may need a pump if the drain sits below the sewer line. Plan the plumbing first so everything else fits around it.

Old homes

Remodels in older Topeka houses often uncover galvanized supply pipe or cast iron drains. Replacing them while the walls are open avoids having to open them again later. See old galvanized pipes.

Appliances

Dishwashers, ice makers and washing machines need their own connections and shut-offs. Braided steel hoses last longer than rubber ones. Send a request and a plumber will get in touch.

Shut-off valves

Each sink and toilet should have its own shut-off valve so you can stop the water at one fixture instead of the whole house. Valves that haven't been turned in years often stick or start dripping when used. Replacing them during any fixture job is quick and saves trouble later, especially in older homes where the original valves are decades old.